Heidenhain pc software install#
Heidenhain pc software serial#

Heidenhain pc software serial#

Set the serial A-B switch box to the proper PC.Set the lab's serial A-B-D-E switch box to the Heidenhain/Bridgeport position (E).Transfer the program into the run buffer then dry run the program for an error check.Will display the last line in the program that was accepted. It is possible that the transmission might be interrupted by a syntax or data error. Transmission, the program will be displayed on the CRT in the edit mode. Program is being 'read-in' to the controller. The CRT will read 'EXTERNAL DATA INPUT' and the program's number while the.Back at the PC, type in from the DOS prompt:.(b) delete the conflicting program from the Heidenhain's memory.

If necessary, either (a) go back to theД¬omputer and edit the statement, changing the program number to one not already in use or Number contained in the first (and last) statement in your program. The number MUST be exactly the same as the program identifier

Key in the number to be assigned to the program by the controllerВ—its.

Use the cursor keys to highlight the 'READ-IN SELECTED PROGRAM' prompt and.

Immediately after the '%' character, view the file by pressing the F3 function key (press

If you do not know the program identifier number (the number at the top of the file.

Use the cursor arrows to highlight your program's filename.

Press the TAB key to move back and forth between the left and right panels.

Then type in A (for 5-1/4' disk) or B (for 3-1/2' disk).

Display your floppy disk's files in the left panel by pressing the key and at the.

If the Norton Commander DOS shell is not active, type in NC and press the key.

Use Norton Commander to locate and highlight your program's file name.

Heidenhain pc software install#

Install the disk containing your program.

At the PC's DOS prompt, type in HEID-24 and press the key to run a batch file that sets up the correct communications parameters ( MODE COMx 2400 E 7 2).

If applicable, set the serial A-B switch box to the proper PC.

If applicable, set the lab's serial A-B-D-E switch box to the Heidenhain/Bridgeport position (E).

Ensure the PC-Heidenhain Serial Communications Cable is connected to the back of the Heidenhain Controller and to either the appropriate COMM port on the PC or to the serial stitchbox.

Ask your instructor for specific instructions on the current data Of the computers in the lab will be undergoing serious upgrades, these directions may be The following procedures have been written to reflect the PC hardware and softwareДЄvailable in the ETSU Machine Tool Lab (Room 103 Wilson-Wallis Hall). Programming & Operating Instructions Chapter 9Дata Transfer: PC CNC The Ins and Outs of Remote Data Input and Output Using PCs PC to Heidenhain Data Transfer Heidenhain CNC Mill Pgrm & Op Instr - Chapter 9 PC-CNC Data Transfer